Posted on

Release – gSender 1.6.5

Dog in an astronaut helmet sits on the Moon, announcing gSender 1.6.5 new release for CNC workflow.

Hey Folks,

We have yet another gSender release for everyone that mainly addresses some of the reported problems over the past two months.

New Additions

  • Probe corner selection is back. After some requests to bring the feature back, we decided a good middle ground would be to add it as a setting on the config page. This way, users have the option to customize the behaviour, while reducing the chances you are selecting the wrong option.
Screenshot of gSender CNC software showing Probe settings with Corner set to Bottom Left and related options visible in a settings grid, left navigation showing 'Basics' and 'Probe' tabs, and a Disconnected banner at top.

Improvements

  • Firmware settings now have minimum and maximum values, preventing you from setting an out-of-bounds value
  • The diagnostics PDF has an improved layout when displaying the config settings
  • Park, Go To Location, Quick Movement, and the TLS manual tool change position now raise Z by the pull-off distance ($27) when the $22 bit 3 is off, instead of a fixed Z-1

Fixes

  • An issue with unit conversion on manual and semi-automatic tool change when $13 is enabled
  • The diagnostics PDF was reporting stale firmware values previously
  • An issue with surfacing plunging into the board when selecting the center start position has been resolved by running the Z retraction move before the X and Y axis move to the starting position
  • General bug fixes and stability improvements

Download

As always, gSender can be downloaded via GitHub:

https://github.com/Sienci-Labs/gsender/releases/tag/v1.6.5